Do you know what you need to pay attention to when using hot melt adhesive film in humid weather?

What are the issues to look out for when facing wet weather to perform as it should? Let's take a look at Pinghu Zhanpeng, a manufacturer of hot-melt adhesive film, to explain it to you in detail.

1. If hot melt adhesive film is produced under this situation, you must pay attention to the temperature and humidity changes in the factory.

2. Changes in temperature and humidity will cause different changes in the hot melt adhesive film, because when it is produced, some of the inks, glues and other raw materials used will cause color changes due to humidity, making it impossible to meet the requirements for accurate colors. Therefore, the requirements for factory buildings need to be tightly controlled during production.

Second point

1. Next, the hot melt adhesive film will use a heat press machine and other equipment during hot stamping.

2. These devices will get damp in humid air, affecting the efficiency and effect of the operation.

3. Then when you start using the equipment, you should let the machine warm up to remove moisture and make the hot stamping effect better.

The third point

1. Do you know what to do when saving the remaining engraving film? The editor recommends that the storage temperature should be within 25 degrees, avoid direct light exposure, and the humidity should be maintained between 55-65%.

2. If it needs to be stored for a long time, you must pay attention to keeping the environment ventilated. This can keep the space in an unobstructed state, which will be more conducive to storage.

The foregoing are a few of the points to be attended to in the case of hot molten adhesive films exposed to humid climates. I hope this will be of some help to you.